Clara Lydney Black and Brass LED Electric Fire
- 2.0kW Heat Output
- LED Technology
Clara Lydney LED Electric Fire
- LED Technology - low energy flame effect
- Powerful 2.0kW heat output
- Flame-effect only setting - without heat
- Log effect fuel bed
- OVERVIEW: Great entry level electric fire with LED flame effect
The Clara LED inset electric fire features LED technology designed to significantly improve the flame picture and running performance. LED technology not only provides a deeper, richer flame picture with enhanced flame movement but is also a fraction of the cost to run when compared to a conventional incandescent bulb. It will last a lot longer too. To keep operation simple there are three switch settings: 1) Flame effect only, 2) Flame + 1.0kW Heat and 3) Flame + 2.0kW Heat. The controls are located high underneath the hood for easy accessibility. A discrete fan heater provides forward directional heat and is of good quality to reduce operating noise. The Clara fits a standard fireplace opening, typically 16" wide x 22" high (please refer to specification).
For added convenience one spacer frames is provided (supplied fitted) to allow the Clara to be taken out of the box, placed flush against a flat wall and plugged in for instant heat - no chimney or flue depth required. For installation into a fireplace opening, the spacer frame can be removed. This provides the following options: fully inset (0 spacers - requires a 62mm fireplace depth) or flush-fit (1 spacers - 0mm fireplace depth).
The Lydney has a classic traditional design with ornate vertical bars and delicate form. The moulded plastic front has a bowed profile which features two brass decorative finials and is integrated to the fire. The electric fire has a moulded black frame with a brass inlay design and is fixed to the fire.
Please note the price is dependent upon the final configuration.
This information is intended for guidance only. Superior Fires recommends booking a Home Survey to determine whether this appliance is compatible with your requirements.
|Heat Input Gross (High)||2.0kW|
|Heat Input Gross (Low)||1.0kW|
|Heat Output Gross (High)||2.0kW|
|Heat Output Gross (Low)||1.0kW|
|Heat Type||Fan Heater|
|Chimney Flue Compatibility||No Chimney or Flue Required|
|Control Location||High Level - Front - Below Canopy (Manual - Switches)|
|Air Vent Required||Not Required|
|Manufacturer Guarantee||3 Years|
|Min. Room Size Required||None|
|Safety Features||Thermal Trip Switch|
|Installation Requirement||Qualified Electrician Recommended|
|Installation Information||All electric fires feature an automatic safety cut-out device. Simply plug into a standard socket. No chimney or flue required. Designed for use in Great Britain and Republic of Ireland only. All fires must be installed in accordance with the manufacturer’s installation and user instructions and current Building Regulations.|
|Technology||Low energy LED flame effect|
|Power Voltage Supply||220 - 240V|
|Width Outline A||530mm|
|Height Outline B||635mm|
|Depth Outline C||62mm|
|Depth Spacer 1 C1||65mm|
|Rear Width Min D1||390mm|
|Rear Width Max D2||535mm|
|Rear Height E||550mm|
|Opening Width Min X1||400mm|
|Opening Width Max X2||450mm|
|Opening Height Min Y1||560mm|
|Opening Height Max Y2||580mm|